Deutz Stage 3B, T (C) D3.6 L4, Common-Rail, Bosch EDC17 | PRCS-Deutz-stage-3B

Deutz Stage 3B, T (C) D3.6 L4, Common-Rail, Bosch EDC17, Komplete set with 7 Y-cables, plus 18 Pin Kunstof Breakout Box PRTK-BOB18.
The Y-cable or splitter cable is placed between the sensor/actuator and cable tree connector so that the sensor can normally function in a working motor management system. By connecting the 18 pin breakout box to this cable, a measurement of the signals to and from the sensor can be taken in a safe and reliable way. This can be done by using a multimeter or scoop. The pin occupation with the pin numbers on the connector is the same as the number of songs on the Breakout Box. In this way, cables no longer have to be punctured to measure a signal. The use of paper clip and measuring along the seals is therefore a thing for the past. Thus there is no hole in the insulation of the wire, or the seal and the copper of the wire, cannot oxidize and cause the necessary problems in the future. Nor will there be measured in a separate connector with the chance of damage to the contact. Moreover, the sensor also no longer works with a separate connector!
Deutz Stage 3B, T (C) D3.6 L4, Common-Rail, Bosch EDC17, click here for a overview with photos.

Pry3-0033
Inlet Pressure sensor / folder sensor

Pry4-0011
Oil Pressure (And Temperature) Sensor / Engine to Fuel Sensor, C162

Pry2-0021
Coolant Temperature sensor / camshaft position sensor / crankshaft position sensor / fuel injector / inlet Metering Valve or mprop

Pry3-0024
Fuel Rail Pressure Sensor

Pry5-0013
EGR VALVE WITH Position sensor

Pry2-0029
Engine Stop C164B / AC Clutch

Pry2-0022
Wif sensor 2 pin